Imported optical fiber welding machine maintenance method

by:Tumtec      2020-03-29
Imported optical fiber welding machine maintenance method when workers in the normal operation of the welding machine to avoid sometimes appear a few problems, such as boot anomaly, noisy, welding is not stable, and so on. Here we will learn together in the optical fiber welding machine maintenance tips. A welding machine, optical principle in start up, open the wind cap found abnormal white light is not bright, Machine also do not have any response) Anomalies ( 1) Batteries or power converter bad ( 2) Power on key poor contact ( 3) Abnormal power fuse ( 4) The machine internal short-circuit fault (or 5) Use battery, the battery voltage is insufficient or reverse polarity. Solution: first check machine power fuses are in good condition, if damaged need to replace the fuse ( Welding electrical source for 8 a, the power converter is usually 3 a) , you need to confirm the power supply output voltage is about 12 ~ 13 v. Check the polarity of the battery have any counter, if necessary. Then restart the welding machine, is still not solved, need to return factory repair. 2, welding machine after startup, show only the ICONS, machine without any response. Anomalies ( 1) The keyboard of the reset button to abnormal, the springback. ( 2) The inside of the welding machine circuit malfunction. The solution: first to forcibly hold the 'reset' button, and then let go, repeated several times, see can solve the problem, or return to the maintenance department in the keyboard. Third, after startup, welding machine always shows system reset reset can't stop. Anomalies ( 1) New welding machine could be the photoelectric switch off or induction on the camshaft column. ( 2) The old welding machine photoelectric switch block slice deformation or big gap between clamp and the nose plate is too small, hinder the linking piece backward movement. ( 3) There is something wrong with the motor or motor driver solution: loosen the two welding machine cover socket head bolts, remove the cover plate welding machine. If is induction column away, to plug the hole in the side of the camshaft, with glue. If it is a big plate led photoelectric switch block slice, clamp block with forceps, gently pull (test whether reset to stop again. If it's with a travel switch control reset, remove the dirt in the switch. Still cannot solve the problem of returned to the factory, the above are common problem of optical fiber welding machine maintenance and processing method, I hope it can help the user.
Custom message
Chat Online 编辑模式下无法使用
Chat Online inputting...