Optical fiber welding machine failure analysis and solution!

by:Tumtec      2020-05-23
Optical fiber welding machine failure analysis and solution! A, optical fiber welding machine in welding process shows 'can't find the fiber or fiber surface is not clean'. This first because the surface of optical system caused the pollution, protect the glass should be cleaned with anhydrous alcohol ( Located just below the electrode) , fiber cleaning pressure together with the lens. The ratio of alcohol dry again after welding. If the fault can't be ruled out, machine maintenance need repair service center. B, optical fiber welding machine in welding process to show 'fiber migration is too big. The primary cause of this situation because of V groove groove with dirt, need to clean the V groove. When cleaning with anhydrous alcohol for cleaning, can use toothpick or high pressure within the tank on stolen goods gas cleaning, pay attention to, not with solid objects for V groove cleaning operations, so easy to form a V groove damage. If after cleaning can't eliminate 'fiber migration is too large, the drive recovery, also can't repair, artificial regulation requires repair service center. C, fiber found in welding process, welding part is unusual, electrode discharge is not uniform. This first because the tip of the electrode is oxidation, because the tip is the presence of oxide, makes the electrode discharge evenly, welding quality is bad. Need to clean the electrode. If can't normal discharge after cleaning, need to be replaced electrode. Under normal circumstances, the electrodes in welding need to clean the electrode 500 times or so, the use of the 1000 or so you will need to replace the new electrode. Please use original electrode when replacing electrode, and using other can't guarantee the normal work of the function of welding electrodes, it might damage the welding machine. D, prompt replacement electrode welding machine. This is because the welding machine set up remind replacing electrode Settings, please clean the electrode when prompted to replace electrode, can together into welding machine parameter Settings for change of this parameter. Standards set for 1000 times. E use time reduce welding machine battery, battery and cell phone battery, need to pay attention to using the method, under normal circumstances, when the battery capacity is above 30%, please try to use batteries for power supply. Together, please note that when using an alternating current power supply, will be together for welding machine battery recharged. After found that cells use time reduced, can carry on the three times the depth of the charge and discharge the battery, so the use of the battery time can be prolonged. Once found the battery fast charge, and shorter working hours, please to three times the depth of the charge and discharge, if cannot be ruled out fault, indicate the battery life to the limit, need to replace the original rechargeable batteries. E use time reduce optical fiber welding machine battery, battery and cell phone battery, need to pay attention to using the method, under normal circumstances, when the battery capacity is above 30%, please try to use batteries for power supply. Together, please note that when using an alternating current power supply, will be together for welding machine battery recharged. After found that cells use time reduced, can carry on the three times the depth of the charge and discharge the battery, so the use of the battery time can be prolonged. Once found the battery fast charge, and shorter working hours, please to three times the depth of the charge and discharge, if cannot be ruled out fault, indicate the battery life to the limit, need to replace the original rechargeable batteries.
Custom message
Chat Online 编辑模式下无法使用
Chat Online inputting...