Optical fiber welding machine in the up and down in optical information about moving back and forth!

by:Tumtec      2020-04-01
Optical fiber welding machine in the up and down in optical information about moving back and forth! In welding machines is to present the left or right side in the process of optical phenomenon is mainly to move up and down shift in fiber position in V groove. The second is caused by fiber presser foot doubt. The above fault solution: 1 > press the 'reset' button to reset the system. 2 > check the bare fiber is clean, if not clean the handle. 3 > check Y/Z direction of the two optical fiber end face position error is less than 0. 5 mm, if less than for the following operation, or to the factory to repair. 4 > clean fiber dust deposition in the V groove welding machine. 5 > small buckle head with his fingers, concluded that small head is compaction fiber, without pressure in dealing with it. If still there is no handle, please contact repair units
Custom message
Chat Online 编辑模式下无法使用
Chat Online inputting...